The back of the frame has a generous beavertail. The Springfield Hellcat has a trigger lever safety, but unlike the striker-fired XDs, there is no grip safety. Regardless of your opinion, the Hellcat manages to transcend those advertisements and pleases virtually everyone. As a result of our tests, Guns & Ammo Staff has determined that grip angle is a subjective preference despite a company’s marketing. The results are minimal muzzle rise during recoil. With the two pistols side-by-side, you can’t argue that Springfield Armory did a more effective job at covering the frame with textured touchpoints.Īt the back of the grip, the beavertail extends beyond the rear of the slide and encourages a high grip that works in conjunction with the high triggerguard cut above the frontstrap. This texture also appears above the triggerguard where your idle trigger finger would naturally rest between volleys or your support-hand thumb on the opposite side. The Hellcat’s textured surfaces improve on the ergonomics of the P365 with texturing on the Hellcat’s thumb shelves (above the reversible magazine release). It’s just large enough to offer a full grip with the extended magazine. The original mold was hand stippled with high and low points for two levels of aggressiveness, depending on how hard you grip the frame. The Hellcat’s frame is a textured, polymer-made tactile with molded stippling. Carry the Hellcat with the extended magazine, and the Hellcat duplicates the capacity of the original Browning Hi Power 9mm. The Hellcat, with the smaller, easier-to-conceal, flush-fit magazine inserted, matches the capacity of two six-shot revolvers. Let’s put the Springfield Hellcat’s magazine capacity in perspective. Check here for some holster options from Crossbreed. Even with the higher ammunition capacity, the Springfield Hellcat is for perfect for concealed carry. For the Hellcat 9mm subcompact, Springfield’s design team created a patented magazine that can hold 11 rounds in the flush-fit mag and 13 rounds into the extended version. This centers each round to the feed ramp each and every time. At the top, the body tapers to form a single stack. The magazine type used by SIG Sauer for the P365 and the Honor Defense pistol is often described as a “stack and a half.” However, at the bottom of the magazine it is more like a double-stack magazine.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |